[Eisfair] E1 lässt sich nicht installieren

[Holger Bruenjes]

Hallo Thomas

Am 2014-10-25 um 18:23 schrieb Thomas Amborn:

> 00:1f.5 IDE interface: Intel Corporation 82801I (ICH9 Family) 2 port
> SATA Controller [IDE mode] (rev 02) (prog-if 85 [Master SecO PriO])
> 	Subsystem: ASUSTeK Computer Inc. Device 8277
> 	Flags: bus master, 66MHz, medium devsel, latency 0, IRQ 22
> 	I/O ports at c000 [size=8]
> 	I/O ports at bc00 [size=4]
> 	I/O ports at b880 [size=8]
> 	I/O ports at b800 [size=4]
> 	I/O ports at b480 [size=16]
> 	I/O ports at b400 [size=16]
> 	Capabilities: [70] Power Management version 3
> 	Capabilities: [b0] Vendor Specific Information: Len=06 <?>
> 	Kernel driver in use: ata_piix

>
> 03:00.0 IDE interface: Marvell Technology Group Ltd. 88SE6121 SATA II /
> PATA Controller (rev b2) (prog-if 8f [Master SecP SecO PriP PriO])
> 	Subsystem: ASUSTeK Computer Inc. Device 82a2
> 	Flags: bus master, fast devsel, latency 0, IRQ 16
> 	I/O ports at ec00 [size=8]
> 	I/O ports at e880 [size=4]
> 	I/O ports at e800 [size=8]
> 	I/O ports at e480 [size=4]
> 	I/O ports at e400 [size=16]
> 	Memory at febffc00 (32-bit, non-prefetchable) [size=1K]
> 	Capabilities: [48] Power Management version 2
> 	Capabilities: [50] MSI: Enable- Count=1/1 Maskable- 64bit-
> 	Capabilities: [e0] Express Legacy Endpoint, MSI 00
> 	Capabilities: [100] Advanced Error Reporting
> 	Kernel driver in use: pata_marvell

Kannst Du eisfair auf einen USB-Stick installieren und damit die 
Kiste booten und dann nochmal lspci -v machen

Holger